Configuring the RaQ from the LCD panel: Difference between revisions

From Edgar BV Wiki
Jump to navigation Jump to search
New page: <pre> You access each of these functions by holding down the (select) button on the LCD console for approximately two seconds. This action causes the LCD screen to enter its function mode....
 
No edit summary
 
Line 13: Line 13:
To reset the IP address or change the network configuration of the Network 1
To reset the IP address or change the network configuration of the Network 1
interface:
interface:
1.On the LCD console, whonl d thdeo utbton for approximately
1.On the LCD console, hold down the S for approximately
2 seconds.
2 seconds.
The LCD screen displays:
The LCD screen displays:
SELECT:
SELECT:
SETUP NETWORK
SETUP NETWORK
2.Press the utbton.
2.Press the E button.
3.Enter the IP addreusss ing the arrow buttons. The left and right arrow buttons
3.Enter the IP addreusss ing the arrow buttons. The left and right arrow buttons
move the cursor position to the left or right. The up and down arrow buttons
move the cursor position to the left or right. The up and down arrow buttons
increase or decrease the digit at the cursor position.
increase or decrease the digit at the cursor position.
4.Press the utbton.
4.Press the E button.
5.Enter the Netmask using wth e utbtoanrrso.
5.Enter the Netmask using the arrow buttons.
6.Press the utbton.
6.Press the E button.
7.Enter the Gawteay using thew uatrbtroons.
7.Enter the Gawteay using the arrow buttons.
8.Press the utbton.
8.Press the E button.
9.Use the arwro utbtons to toggle the cursor vbe tweaennd [[SC]a]a ncel.
9.Use the arrow buttons to toggle the cursor between [S]ave and [C]ancel
10.Press the button.
10.Press the E button.
If you select the Save option, the RaQ 4 reboots using the new network
If you select the Save option, the RaQ 4 reboots using the new network
configuration. If you select Cancel, you return to step 1 of this procedure.
configuration. If you select Cancel, you return to step 1 of this procedure.
</pre>
</pre>

Latest revision as of 13:49, 29 October 2007

You access each of these functions by holding down the (select) button on
the LCD console for approximately two seconds. This action causes the LCD
screen to enter its function mode. Press the button until the function you
want appears on the LCD screen. To cancel the LCD function mode, select the
EXIT
function when it appears on the screen. Press the (enter) button and
select
YES
.

Changing network configuration
To reset the IP address or change the network configuration of the Network 1
interface:
1.On the LCD console, hold down the S for approximately
2 seconds.
The LCD screen displays:
SELECT:
SETUP NETWORK
2.Press the E button.
3.Enter the IP addreusss ing the arrow buttons. The left and right arrow buttons
move the cursor position to the left or right. The up and down arrow buttons
increase or decrease the digit at the cursor position.
4.Press the E button.
5.Enter the Netmask using the arrow buttons.
6.Press the E button.
7.Enter the Gawteay using the arrow buttons.
8.Press the E button.
9.Use the arrow buttons to toggle the cursor between [S]ave and [C]ancel
10.Press the E button.
If you select the Save option, the RaQ 4 reboots using the new network
configuration. If you select Cancel, you return to step 1 of this procedure.