Domoticz: Difference between revisions
| Line 39: | Line 39: | ||
= Evohome= | = Evohome= | ||
[https://www.domoticz.com/wiki/Evohome Evohome in wiki] | [https://www.domoticz.com/wiki/Evohome Evohome in wiki] | ||
Go to Setup -> Hardware. Next to Type, select Evohome via Web API | |||
Under username / pass, fill in your mytotalconnectcomfort.com credentials. Make sure Synchronise, show schedule and location are all on. You may either lower or raise the poll intervall to anything you like but if you set it to less than ten seconds it will automatically reset itself to 60 seconds. | |||
After pressing the 'Add' button to add the hardware device, the rest of the configuration will occur automatically and you should see your Evohome heating zones (and Hot Water device if you have one) appear in the devices list after about ten seconds. If you like you can now disable 'Synchronize installation'. | |||
Revision as of 10:15, 1 April 2019
Install
When installing there are two choices
- hand compile
- use curl (for the "easy" way)
Curl
Domoticz from binary comes with a static openssl1.0.0 dependency, which Debian no longer offers. So first
cd /usr/local/src wget http://security.debian.org/debian-security/pool/updates/main/o/openssl/libssl1.0.0_1.0.1t-1+deb8u11_amd64.deb dpkg -i libssl1.0.0_1.0.1t-1+deb8u11_amd64.deb apt-mark auto libssl1.0.0 apt install libpython3.5 libpython3.5-dev curl -sSL install.domoticz.com | bash cd /opt/domoticz/ ./updatebeta
(NB I install to /opt/domoticz)
Check if everything is running ok
journalctl -full -u domoticz.service
In the web interface go to Setup -> Log and check more
if links don't work, look here and choose the one with your architecture. Unstable only works on ARM
by hand
There is some flag about not using staticssl
when visiting the SSL site, you may need to remove the port number the installer gives you and just go to https://ip
Evohome
Go to Setup -> Hardware. Next to Type, select Evohome via Web API
Under username / pass, fill in your mytotalconnectcomfort.com credentials. Make sure Synchronise, show schedule and location are all on. You may either lower or raise the poll intervall to anything you like but if you set it to less than ten seconds it will automatically reset itself to 60 seconds.
After pressing the 'Add' button to add the hardware device, the rest of the configuration will occur automatically and you should see your Evohome heating zones (and Hot Water device if you have one) appear in the devices list after about ten seconds. If you like you can now disable 'Synchronize installation'.