Pwnagotchi
Pwnagotchi.ai installation guide
Adafruit PiRTC DS3231 remove the GPIO connector and then solder
2017 info on using DS3231 Real Time Clock
Use
hwclock
For output
Waveshare e-ink display test utility
Networking
Via USB
change ethernet gadget (usb network) to a stable MAC address (choose whatever mac you like)
add the following to the end of /boot/cmdline.txt
g_ether.host_addr=86:5A:EE:60:99:4B g_ether.dev_addr=86:5A:EE:60:99:4B
In nm-connection-editor you can set the ipv4 settings on your linux box to 10.0.0.1/8 and then enable connection sharing and you can ssh in.
ssh pi@10.0.0.2
You may or may not need these firewall rules
#!/bin/bash sudo ip route add 10.0.0.0/8 dev enp0s20f0u1
~$ ip route list default via 192.168.0.1 dev wlp4s0 proto dhcp metric 600 10.0.0.0/8 dev enp0s20f0u1 proto kernel scope link src 10.0.0.1 metric 100 169.254.0.0/16 dev wlp4s0 scope link metric 1000 192.168.0.0/24 dev wlp4s0 proto kernel scope link src 192.168.0.55 metric 600
Wifi
you can't use iwconfig to connect the wireless, you have to use wpa_supplicant. raspi-config won't work because the pwnagotchi scripts put wifi in monitor mode. You need to change the wireless interface back to managed mode.
DNS
You will also have to add a DNS server to /etc/resolv.conf through /etc/dhcpcd.conf
vi /etc/dhcpcd.conf
Then, add this line:
static domain_name_servers=1.1.1.1 8.8.8.8
There is a problem with dnsmasq clobbering resolvconf. There seem to be a few ways to solve this
/etc/dnsmasq.conf add
server=1.1.1.1
OR
add...
DNSMASQ_EXCEPT=lo
to /etc/defaults/dnsmasq from here
OR
implement some of the resolvonf ingoring lines in /etc/dnsmasq.conf
General Configuration
raspi-config
Is your friend
There are 2 webinterfaces: https://piface.local:8080 which will show you the screen but with options to reboot and configure some stuff and https://piface.local:8081 which allows you to play with bettercap.
/boot/config.txt /etc/pwnagotchi/config.toml /etc/pwnagotchi/default.toml (copy from here into config.toml)