Wifi Pineapple Nano

From Edgar BV Wiki
Revision as of 09:17, 25 March 2020 by Unknown user (talk) (→‎Linux)
Jump to navigation Jump to search

Setting up

  • Download the firmware Hak5 download centre
  • plug in the pineapple to the PC using the USB Y-cable: both USB ends in the PC and the female usb onto the pineapple
  • surf to http://172.16.42.1:1471
  • follow instructions and then:

Windows

  • you get a new network connection
  • In network connections rename the new ASIX USB network to pineapple using F2
  • In your internet connection, right click -> properties -> sharing -> set to on -> select pineapple in the drop down list (home networking connection) and apply
  • Pineapple connection, right click -> properties -> set ipv4 address to 172.16.42.42, netmask 255.255.255.0. Gateway and DNS stays empty

Now continue under Both

Linux

  lsusb 

shows you an ASIX fast ethernet card

  ifconfig | grep eth 

shows you a new usb ethernet port

  wget wifipineapple.com/wp6.sh
  chmod +x wp6.sh
  sudo ./wp6.sh

Because the wp6.sh script doesn't write the route properly, using C to connect results in a message: "Detecting Wifi Pineapple......." and endless dots. To fix this

  sudo ip route add 172.16.42.0/24 dev enx00c0ca9153f3

And then run the wp6.sh script and use the C button.

Both

Now you can surf to http://172.16.42.1:1471 and load the bulletins - now you know you're online.